0
items
$0
FALCON CABINET RGB EDGE
Exclusively on our FALCON arcade machines you’ll find RGB LED edge molding. We’re now in version 3.0 of this hardware, revision information below.
Version 3 (2024)
VERSION 1 (2021)
1.0 was typical t-molding with built-in sleeve for RGB LED strips. This stuff is seen today on Raw Thrills arcade machines.
PROS:
- Pre-packaged t-molding form factor
CONS:
- Hard to install without LED breakage, hard to bend sharp corners
- Almost impossible customers to replace if damaged or burnt out
- Non-diffused appearance
- Long installation time with soldering required
Detail of visible individual LEDs
VERSION 2 (2023)
This time we got a nice diffused look on the sides, but the front profile was a little inconsistently lit and dim. Installation on this is messy, applied almost like a purfling using similar tape and adhesive techniques.
PROS:
- The look is nice on the sides, very diffused
- Readily available as “neon strips”
CONS:
- Messy, time consuming installation using adhesives
- We consider it “not customer replaceable” if damaged or burnt out
- Not very durable
- Slightly more narrow than the cabinet edge, extra steps needed for alignment and covering the reveal
VERSION 3 (2024)
We designed this version from the ground up for the nicest look yet with the most customer benefits. It’s a mix of acrylic and ABS and took a long time to get right. This stuff looks great and is easy to replace if it ever burns out. Super durable too!
PROS:
- Perfectly diffused from all sides
- Very durable
- Easy to replace the LEDs inside
- Custom made for a perfect fit on our cabinets
CONS:
- Material cost is a higher
- Requires more manufacturing
- Mounting hardware is visible (but covered with side art along the outer edges)
